3100030217

Electronic indicating instrument with digital LCD readout, designed for connection of the active electrodes, with additional measuring device for structural moisture using the electrical resistance measuring principle. (for structural moisture-air humidity-temperature).

Technical data:

- Direct display of readings by large LCD readout. Resolution 0.1 digits.

- Size: length 140 mm × width 90 mm × height 42/50 mm. weight without accessory 230 g.

- Power supply: 9 V dry battery IEC 6 F 22 or, optionally, rechargeable battery.

Structural Moisture

-  MB 35 For surface moisture measurement on concrete.Measuring range: 2 to 8 % m.c. (according to oven test).

-  B 50 For the detection of dampness in all kinds of building materials. Measuring range: 0 to 199 digits (scanning range) 0.3 to 8.5 % of dry weight or 0.3 to 6.5 % CM by conversion table

-  B 60 Identical with B 50 but additionally equipped with limit value selector and acoustic signal generator.

-   With incorporated resistance measuring circuit for fast moisture measurement in set building materials. Measuring range: 0 to 80 digits, with conversion graphs for percentage readings.

Air Humidity

-  RF-T For fast measurement of air relative humidity and air temperature. Measuring ranges: 5 to 98 % R.H. and –10 to 80 °C.

Temperature

-  IR 40 Fast surface temperature measurements using infra-red sensor. Measuring range: –20 to 199.9 °C.

-  PT 100 For fast temperature measurement. Ten different probes available. Measuring range: –199.9 to 600 °C.

-  MH 34 For measurement of high moisture values in conifers. Measuring range: 40 to 200 % m.c.

Suitable Electrodes:

-   for Structural Moisture: MB 35, B 50, B 60, RF-T 31, RF-T 36, M 6, M 6-150/250, M 6-Bi 200/300, M 20-Bi 200/300, M 21-100/250, M 25

-  for Air Humidity: RF-T 28, RF-T 31, RF-T 32, RF-T 36

-  for Temperature: IR 40, OT 100, OTW 90, ET 10, ET 50, TT 30/40, LT 20, FT 2 – 30

-  for Wood Moisture: MH 34 (only for high moisture contents with conifers)